computerrepairs.ca

Simulator

http://computerrepairs.ca/Simulator.htm

Update Aug, 2016: The simulator described below is being offered for sale. For those that have an interest, I have put together these few pages of pictures to help show the ever changing process of building this helicopter simulator. The Bell 206BII flight deck was salvaged from a roll over accident that had caused some damage to the helicopter's front left side. All of the original flight controls,. For the most part this has been made possible by the DodoSim 206 FSX helicopter simulator software from D...

Simulator_Parts_Fabrication

http://computerrepairs.ca/Simulator_Parts_Fabrication.htm

For Bell 206 helicopter simulators. On this page you will find the collective controls that I have been fabricating for real world commercial training simulators. The collectives are made from 6061-T6 aluminum and the parts are machined individually on a lathe/mill. These collectives were built for the realistic assignment features of the Dodosim 206 FSX aircraft. The collective controller is intended to be permanently mounted to the seat base of the flight deck. Bell 206 Type Collective. Note that these...

Cyclic_Control

http://computerrepairs.ca/Cyclic.htm

For Bell 206 type helicopter simulators. Bell 206 Type Cyclic Controller. Cyclic is equipped with Honeywell SS495 Hall effect sensors on the roll and pitch axis. 1 1/4 O.D. 6061-T6 aluminum cyclic sticks. The tubing is first heated, bent to shape,. And finally a black powder coat finish is applied. 206 style grip,. With 20 degree offset to stick, and two push button momentary switches. Mounting brackets support pitch axis ball bearings and adjustable pitch axis stops.

Pedals

http://computerrepairs.ca/Pedals.htm

Bell 206 type pedal set. The pedal levers are 1 1/4 x 1/2 6061 aluminum flat bar welded to 1 1/4 x 1/4 pedal foot pad. Replaceable 1/2 ID x 1 long oil bronze bushings are pressed into pedal lever. Bellcrank pivot shaft is 1/2 with replaceable 1/2 ID oil bronze bushings. Enclosed Honeywell SS495A Hall effect sensor is used to keep track of bellcrank position. Dual Control Pedal Sets. For teaching and trainer type simulators).

Site Map

http://computerrepairs.ca/Training_Sim.htm

The gauges and instruments are displayed by a single LCD monitor behind the main panel overlay. Rotary switch encoders are used to control the attitude bar, altimeter, gyro, ADF, and VOR instruments. The Bell 206 annunciator panel was retrofitted with LEDs and a PhidgetLED-64. Goflight radios and switches. Bell 206 overhead panel. This dual control cyclic controller is fabricated from 6061-T6 aluminum. And incorporates precision ball bearings on each axis for strength and smoothness. Shown here is the.