sheetmetalworkbook.com
Circles
http://www.sheetmetalworkbook.com/circles.htm
Three points not in a straight line. Tangent is always perpendicular to the radius. Is part of a circle. Cumference. The symbol for Pi is . Pi=(3.141592654). Cumference = diameter x. Http:/ www.dvcplanners.com. You find this site. No part of this publication may be reproduced, or transmitted, or stored, in any form or by any means, electronic, mechanical,. Photocopying, recording, or otherwise, without the prior written permission of SheetMetalWorkBook.com, Sixth Edition.
sheetmetalworkbook.com
Geometry, Points, Lines, Segments & Rays
http://www.sheetmetalworkbook.com/geometry.htm
POINTS, LINES, SEGMENTS, & RAYS. Lines could establish a point. Right angles.(90 degrees). Below are all parallel to each other. Http:/ www.dvcplanners.com. You find this site. No part of this publication may be reproduced, or transmitted, or stored, in any form or by any means, electronic, mechanical,. Photocopying, recording, or otherwise, without the prior written permission of SheetMetalWorkBook.com, Sixth Edition. Reformatted for Internet, ©2012 SheetMetalWorkBook.com.
sheetmetalworkbook.com
Introduction and Index
http://www.sheetmetalworkbook.com/toc.htm
PRECISION SHEET METAL LAYOUT MANUAL #1. INTRODUCTION (Scroll UP for intro.) 1. ORDER IN THE MATH. GEOMETRY; POINTS, LINES, SEGMENTS, & RAYS. PLANES, PLANE AND SOLID GEOMETRY. LOOKING AT TRIGONOMETRY A COMMON SENSE APPROACH. SOME COMMON SENSE TRIG FORMULAS. WHERE TWO SIDES ARE KNOWN. INTERSECTING LINES AND ANGLE RELATIONS. MORE ON BEND DEDUCTION. 90 DEGREE BENDS Cont. NEUTRAL LINE 90° BENDS. NEUTRAL LINE ACUTE BENDS. NEUTRAL LINE OBTUSE BENDS. 90 DEGREE V NOTCHES. BEND RELIEF SLOTS 34. You find this site.
store.esheetmetalshop.com
DVCBD-Table
http://store.esheetmetalshop.com/DVCBD-Table.html
Bend Allowance, Bend Deduction Tables and Calculator. Excel Spreadsheet (version 2000 ). OK You Precision Sheet Metal Mechanics here is a tool you can use! The Bend Allowance Table will calculate angles up to 360° and Material Thicknesses up to .800 and an inside bend radii up to 630.00. The Angle, Radius and Material Columns can be changed to whatever you want and the whole table is updated to relect the new values! Spreadsheet includes illustrations of how to use Bend Deductions or Allowances.
coultasindustries.com
website
http://www.coultasindustries.com/website.htm
Click thumbnail to enlarge - Click Caption to look at the Website. 169; Coultas Industries, Inc. 2013. The Following images are some of the Websites that we have designed. Coultas Industries was designed by us! Need a Website or Domain Name - Contact us: 575-534-7631 or email David@CoultasIndustries.com.
