model-steam-boats.co.uk
Marten, Howes & Baylis
http://model-steam-boats.co.uk/index.html
Steam Powered Dinghy Henry. Marten, Howes and Baylis. Scale model of a typical clinker built (lapstrake), powered working dinghy of 15ft 6 inches length, used for small vessel harbour towage, as a tender to larger vessels at anchor, or for pleasure. The boat kit and boiler unit are designed and manufactured in UK, the engines are made in France. Please use the buttons at the top of the page to see more. For prices and delivery information please use contact details.
model-steam-boats.co.uk
Marten, Howes & Baylis
http://model-steam-boats.co.uk/henry.html
Steam Powered Dinghy Henry. Marten, Howes and Baylis. The hull is a fibreglass moulding. The keel is constructed from three pre-. Cut layers of 3 mm beech with three layers of pre-. Cut pear at the stem. The interior planking is from 1.5mm pre-. Cut styrene sheet. The ribs and risings are in styrene strip. The gratings are assembled from 3.5mm x 3.5mm pre-. Cut beech. The decks and bottom boards are cut from 1.5mm lime. Marten, Howes and Baylis steam plant for the ‘Henry’ with Anton ‘Quartz’ engine.
model-steam-boats.co.uk
Marten, Howes & Baylis
http://model-steam-boats.co.uk/henry_technical_specification.html
Steam Powered Dinghy Henry. Marten, Howes and Baylis. LENGTH OVERALL: .30.5 (776mm.). MAX BEAM OVER RUBBING STRAKE.12.125 (308mm.). MAX DRAFT OVER SKEG. 3.25 (82mm.). MAX DISPLACEMENT. 8.5 lbs (3.83 kilos). BOILER: VERTICAL, FIRE TUBE, GAS FIRED, ALL COPPER, HARD SOLDERED. BOILER VOLUME .420 grms. HYDRAULIC TEST PRESSURE.150 psi/ 10 Bar. WORKING PRESSURE and SAFETY VALVE SETTING.60 psi/ 4 Bar. GAS TANK CAPACITY.40 grms. HYDRAULIC TEST PRESSURE.350 psi/ 24 Bar. BORE: 8mm x 9mm STROKE. Cut beech. The d...
model-steam-boats.co.uk
Marten, Howes & Baylis
http://model-steam-boats.co.uk/henry_steam_plant.html
Steam Powered Dinghy Henry. Marten, Howes and Baylis. Right; Unit showing ceramic burner. Left; MHB boiler and firebox with Anton ‘Quartz’ engine. This engine is a twin cylinder, double acting piston valve unit of 8mm bore x 9mm stroke. It requires one servo for forward, reverse and throttle. Henry’ steam unit with Typhoon Motors ‘TM1’ engine.
model-steam-boats.co.uk
Marten, Howes & Baylis
http://model-steam-boats.co.uk/henry_gallery.html
Steam Powered Dinghy Henry. Marten, Howes and Baylis. Ready made steam unit with Anton Quartz engine in place. Right: Rear deck removed showing rudder servo and control arm. The specially designed slider comes with the kit. Left: Handed brass fairleads and central bitt. Fittings are solid brass castings and require only light finishing. The deck is constructed from lime and pear planks on a ply base, caulked with black card and sealed. The aft removable deck is planked in the same way.